1> Build bsp-ntotrunk-broadcom-bcm2835-trunk on QNX 6.5.0
	To generate the QNX image for Rapberry PI board, following commands from the command Prompt console:
	
	> cd  bsp-ntotrunk-broadcom-bcm2835-trunk
	> bash
	$ make clean; make all
	
	Image is located at: "bsp-ntotrunk-broadcom-bcm2835-trunk/images/ifs-bcm2835.bin"
	
2> We need one sd memory card 8G (we test with SanDisk 8G). please view "http://www.raspberrypi.org/wp-content/uploads/2012/04/quick-start-guide-v2_1.pdf" for more about it.
    copy files bellows to sd memory card:
	
            "bsp-ntotrunk-broadcom-bcm2835-trunk/images/ifs-bcm2835.bin".
            bootcode.bin
            kernel.img
            start.elf
			
3> Connect PC's serial port to header P1 on Raspberry PI board via an USB-UART converter. 
4> Insert SD card into SD slot of Raspberry PI board.
5> Connect HDMI LCD to Raspberry PI board.
6> Setup serial port for Window PC:

	Baud rate: 115200
	Data: 8 bit
	Parity: none
	Stop: 1 bit
	Flow control: none
	
7> Power up Raspberry PI board.
8> The terminal will output as bellows:

	U-Boot 2013.01-rc1 (Nov 27 2013 - 17:00:39)

	DRAM:  128 MiB
	WARNING: Caches not enabled
	MMC:   bcm2835_sdhci: 0
	Using default environment

	In:    serial
	Out:   lcd
	Err:   lcd
	mbox: Timeout waiting for response
	bcm2835: Could not set USB power state
	Net:   Net Initialization Skipped
	No ethernet found.
	Hit any key to stop autoboot:  0
	reading uEnv.txt
	** Unable to read file uEnv.txt **
	reading boot.scr
	** Unable to read file boot.scr **


9> Enter command as bellows to start up QNX 6.5.0:

	fatload mmc 0 0x00200000 ifs-bcm2835.bin; go 0x00200000
