
To get PC-GEOS working under MS-DOS 6, you will have to make
the following modifications to your system files:

1. Make sure the following line is located somewhere in your
   CONFIG.SYS file: DEVICE=C:\DOS\SETVER.EXE

2. From the DOS prompt, type in the following command, then
   press ENTER: SETVER GEOS.EXE 4.0

3. From the DOS prompt, type in the following command, then
   press ENTER: SETVER SETUP.EXE 4.0

4. Once you have done all this, reboot your computer and try
   PC-GEOS. If it refuses to load, you have two options:
        1. Boot under an older version of DOS
        2. Find and install a newer version of GEOS

                        - BAD AiR ABANDONWARE (http://badair.cjb.net/) -

